Thursday, September 15, 2011

Heart Transplant - Adaptronic + Z27AG





And so the heart transplant begins.







[info from the forums]
PRICING:

We can do all Hardware components for $1300
This includes the
ECU (e420c) = $990
2m Wiring Loom = $99
3Bar map Sensor = $88
Rcolt Adaption board/box= $123





If you are in Sydney and would like us to wire this up for you
We can do this in a day period of $640 for wiring installation.



This includes
All wiring to and from the factory ECU
Wiring loom into car cabin (for protection/ harder to steal)
ECU file upload and checks on idle controls/ cold starts/ warmstarts/ street application.

If you would like to dyno with us we can offer this too.



Please PM or call us at 98999594
Cheers
Shan
Adaptronic
----------------------
Matt noticed a leaky pipe hence the manifold came off




For those who don't know about the serial ports:
One serial port is for connecting either a laptop or a vidigauge
The other serial port is for connecting a wideband O2 sensor or an OBD-Pro.

Also noticed a crack growing in the manifold @_@ for the 2nd time




(The OBD-Pro is needed with the Colt to clear 'pending' error codes once per ECU startup before they become actual error codes and bring on the check engine light.)

So regardless of whether you have a vidigauge, you can't connect a wideband O2 sensor via serial port unless you unplug the OBD-Pro.


For dyno tuning that doesn't matter. Just turn on the car with the OBD-Pro plugged in. Then after a few seconds plug in the wideband O2 sensor instead.
Then change 'second serial port' setting in WARI to select your wideband sensor. Then do your dyno tuning. Then change the setting back when you're finished.

But if you want to run a wideband O2 sensor all the time, it would need to be connected via analog input instead of serial. Choose your oxygen sensor from the list shown in fauxpas' post.


----------------------


http://www.jaycar.com.au/productView.asp?ID=KC5486&CATID=25&form=CAT&SUBCATID=347

Thats the controller. has 2 outputs. 1 output is 0 - 1volt to send signal to stock ecu and other signal 0 - 5v for adaptronic. controller does it all.

No comments:

Post a Comment