E85 Plans - Fuel Pump & Injectors

My Mate Uses: ID1000.18.02.48.11.4

Injector Dynamics Codes:
48 = Length
11 = Diameter
04 = Qty
18 = Car Make ID
02 = Car Model IDSize - 14mm

Nominal Flow Rate – 
1015cc/min @ 3.0 Bar (43.5 psi) Using Gasoline at 52 Degrees C (125 Degrees F)
Maximum Differential Fuel Pressure –
7.0 Bar (101.5 psi)
Fuel Compatibility – 
Compatible With All Known Fuels
Electrical Connector - 
USCAR

Most injector applications fall into one of four standard fitments consisting of two standard lengths, (48mm or 60mm) and 2 standard fuel rail bores (11mm, or 14mm)

Our ones can be found in:
WRX (02-11) / STi (07-11) e.g. 725.18.02.48.11.4

------------------

OEM Subaru Units:
baby blue' = 05 WRX = 440cc.
pink = STi = 550cc.

------------------
Injector cushions / orings (basically comes in a standard rebuild kit) ---> Top feed uses these
------------------

Fuel injectors are a direct fit for Subaru applications with top feed fuel injectors which can be found on Subaru WRX 2002-2014, Subaru STI 2007-2015 as well as other Subaru models with top feed (not side feed) fuel injectors.  Fuel injectors are also considered an upgrade for other applications such as Mazda Miata, Mazda RX8/RX-8, Mitsubishi 3G Eclipse (2000-2005), etc.  Fuel injectors are high impedance/saturated.

------------------


A long time ago i ordered a bunch of AN fittings to redo my fuel reg etc.
This time I hope to actually do it, i got the hardline adapters to AN6.
/oil-cooler-stainless-fuel-lines.html

I have used AF808-02 = LS1 5/16" Push On Fitting
I wanted to have a clean setup hence these fuel rail adapters will come in handy.

Current Fuel Pump: /fuel-pump-install-z27ag.html



I also picked up a new pump just encase (E85 Ready)
DeatschWerks DW300 Fuel Pump - Suit Mitsubishi - E85 Safe 4G63
Mitsubishi EVO 8/9 2003-2007
Pump w/ Kit = 9-301-0847



Pumps fits the same profile as a Walbro GSS342 for a simple drop-in installation

With the large pump, I will require a larger fuel reg, possibly might end up with a TurboSmart Unit.

------------------

What about my flex fuel sensor?
What are the sizes of the flex fuel sensor inflow and outflow lines?
Zeitronix Flow Through Flex Fuel Sensor both tubes are 0.37" and 0.5" at the flange.
Which translate to a 3/8" hence I need two AN6 MALE to 3/8" FEMALE QUICK CONNECT

Pretty Good Read:
/3580-Zietronix-ECA-2-(ethanol-content-analyzer)-install

He uses Russell Fittings, I am using AeroFlow...
 - Russell 644123 -6AN Male to 3/8" SAE Fitting
 - Russell 644113 -6AN Male to 5/16" SAE Fitting
 - Radium PTFE -6AN Hose Assemblies